The Berto IOT Generic driver allows connection of IOT Relay and Sensor devices. Messaging to and from the device is managed by the Berto IOT Gateway. If the device has a custom webview user interface then this can be connected to a Berto WebView driver, from connections, which provides a UI button that can be used to access the webview from a T3 touchscreen.
The Berto IOT Gateway needs to be installed in your project.
Properties
- Device - The selected IOT device to be used by the driver.
- Address - IP Address of device.
- Model - Model of device.
- Manufacturer - Manufacturer of device.
- MAC Address - MAC Address device.
- Firmware - Firmware version installed on the device.
- Relay 1-8 - Current state of relay.
- Input 1-8 - Current state of input switch.
- Power 1-8 - Current power reading.
- Voltage 1-8 - Current voltage reading.
- Button 1-8 - Current contact state.**
- Contact 1-8 - Current contact state.
- Battery - Current battery level.
- Temperature - Current temperature reading.
- Humidity - Current humidity reading.
- Flood - Current flood indicator.
- Tilt - Current tilt reading.
- Vibration - Current vibration reading.
- Luminance - Current luminance level.
Connections
The driver creates the required standard relay and sensor connections.
Release Notes
v1.00 - 2020-06-05
v1.10 - 2020-09-22
- Added Signal Strength property and variable for Wireless devices.
v1.11 - 2020-12-30
- Fixed issue where config change did not update device properties.
v1.12 - 2021-01-14
- Added support for IP address change.
- Added button link bindings for button devices.
- Added supoort for Pressure readings from sensor devices.
- Fixed issue with firmware property not be populated.
Licence
DM